Brian May
Three pickups in series, each with its own on/off and phase switch.
Pick your guitar, solder from a drawing that shows every lug where it sits in the cavity, and check each switch position with a meter before you put the strings back on.
Three single coils on a 5-way blade, with quiet mixes in 2 and 4.
Bridge, both, or neck on a 3-way blade.
Two humbuckers on a 3-way toggle, with a volume and a tone for each.
Wired the same as a Les Paul: a volume and a tone for each humbucker.
The semi-hollow takes the same four-knob wiring as a Les Paul.
A bridge humbucker and two single coils on a 5-way blade.
Two single coils on a 3-way toggle with a volume and a tone. Opens in the builder.
One P-90 with a volume and a tone, like a Junior.
Wirings in the style of the players who made them famous.
Three pickups in series, each with its own on/off and phase switch.
Four push-pulls split each pickup, flip the neck's phase, or put both in series.
Photo: APA, Agency for the Performing Arts, public domain, via Wikimedia Commons
A Strat with a separate switch that adds the neck pickup, for bridge plus neck and all three.
Photo: Jean-Pierre Jeannin, CC BY-SA 2.0, via Wikimedia Commons
Two humbuckers on a toggle. The tone knob splits both, and the volume pulls up a high-pass filter.
Photo: Snowdog, public domain, via Wikimedia Commons
Humbucker, single coil, humbucker on a Super Switch, with a high-pass filter on the volume pull.
Photo: public domain, via Wikimedia Commons
Two humbuckers on a 3-way. The middle plays one coil from each, and the pair stays quiet.
Photo: Carlos Delgado, CC BY-SA 3.0, via Wikimedia Commons
Pick your guitar from the list, or answer a few questions in the builder and it draws one for your parts.
Every wire goes lug to lug, the way the parts sit in the cavity. Step by step mode walks you through it one joint at a time.
Each diagram tells you what your meter should read in every switch position, so you know it's right before the strings go on.
No sound, hum that won't quit, a pickup that's gone quiet. The troubleshooting guide goes symptom by symptom, and each one ends with the meter test that tells you for sure.
Troubleshoot a guitarThe builder asks about your pickups, switch, sounds and knobs one choice at a time, then draws the wiring and checks every switch position before you pick up the iron.
Open the builderCount your pickups and look at your switch. Three single coils on a 5-way blade is a stock Strat. Two single coils on a 3-way blade is a Tele. Two humbuckers on a toggle with four knobs is a Les Paul. If yours isn't here, the builder draws it from your parts.
Use 250k for single coils and P-90s, and 500k for humbuckers. Each diagram lists the values in its parts list, and the builder picks them from your pickups.
A coil split turns off one coil of a humbucker so it sounds like a single coil. A coil tap uses an extra lead partway through one coil's winding, so the pickup plays with fewer turns.
Yes. The circuit is the same, but makers use different lead colors for humbuckers. The Tools page lists the colors by maker, and you should check yours with a meter before you solder.
Every diagram has a meter check: the reading you should see at the jack in each switch position. Test it before you put the strings back on.